I really like your defined increments, .01, .1, 1 etc, but is there a chance you could add an increment of .001. These are very convenient but I need a little finer break down. Gary
Thanks for the suggestion, will keep it in mind for future development In the meantime, you can use the console, or macro buttons as well as a workaround
Thanks for the consideration, I'm not sure what Gcode would set the x,y,z increment to .001. I'll have to research that.
a jog of 0.001 is only useful if your hardware has 1000 steps per mm or more. my Z does 0.01mm per step, so would only actually move every 10 commanded jog steps my X and Y do 0.025mm per step, so would only move every 25 jog commands. meanwhile the display will show each 0.001 jog step but is lying because the hardware will not move until is has a full physical step.
indeed. but the principle still applies (-: I seldom jog less than 0.1mm which is about 4 thou (event hough on Z I can jog 0.01mm which is about 4 tenths). My bit of 'standard Z setting paper' is 0.1 thick so a 0.1 jog goes from not touching to 'grabbed the paper' and I accept that as Z0 though recently I have been using my optocoupled Z sensor more and more.
