Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Cnc Mill using standard and 3d printed cimponents

Discussion in 'CNC Mills/Routers' started by TRMA-Chaser, Aug 26, 2019.

Cnc Mill using standard and 3d printed cimponents

Cnc Mill using standard and 3d printed cimponents

Discussion in 'CNC Mills/Routers' started by TRMA-Chaser, Aug 26, 2019.

I used the cad designs for the c beam to find a solution to my initial sourcing problem. I figured that I could use 2x 20x20 and 1x 20x80 Profil to create a c beam actuator. I sourced all of the profiles from a local machin builder and t-nuts and screws in my local hardware store. Some parts are currently in 3d printed pla for testing reasons.

Mills cnc low budget
  1. TRMA-Chaser

    TRMA-Chaser New
    Builder

    Joined:
    Aug 4, 2019
    Messages:
    2
    Likes Received:
    4
    TRMA-Chaser published a new build:

    Read more about this build...
     
    #1 TRMA-Chaser, Aug 26, 2019
  2. Enterprise

    Enterprise New
    Builder

    Joined:
    Jan 15, 2018
    Messages:
    1
    Likes Received:
    0
    Looks similar to one I made. I did not care for the gantry type that has two motors to move the X axis back and forth. With a stationary X axis, you will probably want to put the X axis mount in the middle instead of on the end. Your table will not give you enough movement in both directions, otherwise.
     
    #2 Enterprise, Aug 27, 2019
  3. TRMA-Chaser

    TRMA-Chaser New
    Builder

    Joined:
    Aug 4, 2019
    Messages:
    2
    Likes Received:
    4
    good point with the X Axis positioning will take a look at it once i can assemble it completly
     
    #3 TRMA-Chaser, Aug 28, 2019

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice