Welcome to Our Community

Some features disabled for guests. Register Today.

Another Z Probe Wizard Issue

Discussion in 'Control Software' started by Bigmontel, Aug 12, 2019.

  1. Bigmontel

    Bigmontel Well-Known
    Builder

    Joined:
    Jan 26, 2019
    Messages:
    58
    Likes Received:
    45
    I recently started having issues with my Z probe wizard. Up till about a week ago it worked as advertised.
    Currently i request Z probe wizard, hit probe, it comes down and touches and stops like its supposed to. When i hit “retract” it doesn’t retract and the window disappears.
    It then goes to the normal control page and appears like it started a job and stopped and the “resume job” button is at the top. If i press it a few times it will retract the bit and then go to the “start job” button like it should appear.
    So then I’m stuck wondering if it was ever zeroed at all. Any ideas?
     
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    13,749
    Likes Received:
    4,070
    Will test for you later today or tomorrow when I get a chance
     
  3. Bigmontel

    Bigmontel Well-Known
    Builder

    Joined:
    Jan 26, 2019
    Messages:
    58
    Likes Received:
    45
    Great! Thanks Peter. I’m running control 1.0.183 on my computer via blackbox.
     
  4. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    13,749
    Likes Received:
    4,070
    sharmstr likes this.
  5. Bigmontel

    Bigmontel Well-Known
    Builder

    Joined:
    Jan 26, 2019
    Messages:
    58
    Likes Received:
    45
    Peter Van Der Walt likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice