Evening All Can I use the xPro V4 Endstops with the xPro V3 controller board, if so how do i wire them without the connectors. Thanks Steve
Thanks for the link Peter. I looked at that earlier today, but it didnt make it clear which wires from the Endstop went where on the Controller Board. I am not great at electronics, and only manage if I have a wiring diagram.
C or GND on the switch -> GND on the XPRO NO (if wiring normally open) or NC (if wiring normally closed) the Endstop signal pin on the XPRO: gnea/grbl and gnea/grbl are also helpful