Welcome to Our Community

Some features disabled for guests. Register Today.

Vertical Mill

Discussion in 'CNC Mills/Routers' started by dtanney, Nov 22, 2017.

  1. dtanney

    dtanney New
    Builder

    Joined:
    Nov 24, 2014
    Messages:
    4
    Likes Received:
    1
    dtanney published a new build:

    Read more about this build...
     
  2. Lee Whiteley

    Builder

    Joined:
    Sep 14, 2014
    Messages:
    23
    Likes Received:
    3
    What kind of spindle motor are you using?
     
  3. dtanney

    dtanney New
    Builder

    Joined:
    Nov 24, 2014
    Messages:
    4
    Likes Received:
    1
  4. Gary Caruso

    Gary Caruso OpenBuilds Volunteer
    Staff Member Moderator Builder

    Joined:
    May 19, 2016
    Messages:
    1,184
    Likes Received:
    531
    what linear bearings are you using.. I see MGN12, from where, how do you like them? Thanks
     
  5. dtanney

    dtanney New
    Builder

    Joined:
    Nov 24, 2014
    Messages:
    4
    Likes Received:
    1
    The ones I got are in the links below. They are nice but a little loud (not loud enough to be noticeable with stepper motors and the spindle moving) maybe some lithium grease will fix them up. The only thing about them is they require a lot of screws to hold them down but the rigidity of them make it worth it.

    I got these ones
    MGN12H Linear Sliding Guide / Block 250 300 350 400 450 500 550mm CNC 3D Printer | eBay
    along with for extra blocks
    MGN12H Linear Sliding Block Carriage 45x27x10mm for Guide Rail CNC XYZ DIY TE808 | eBay
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice