Welcome to Our Community

Some features disabled for guests. Register Today.

New machine, question on lead screw tension

Discussion in 'CNC Mills/Routers' started by Retrosmith, Nov 16, 2017.

  1. Retrosmith

    Retrosmith Guest
    Guest Builder

    [Deleted]
     
    #1 Retrosmith, Nov 16, 2017
    Last edited by a moderator: Jan 12, 2018
  2. Rick 2.0

    Rick 2.0 OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Dec 20, 2013
    Messages:
    2,852
    Likes Received:
    1,524
    You might watch the SMW3D video on tensioning the screws. You shouldn't need to shave more than 1/2" off the C-Beams to make it work. Simply reverse the end plates and drop F8-16M bearings in the bearing recess. Lock collar on the free end and the flex coupler on the other. You'll either need to add a few shims under the coupler or order some shorter stand-offs for the motor as the separation distance becomes a little more critical.
     
  3. ChadRat6458

    Builder

    Joined:
    Dec 10, 2014
    Messages:
    93
    Likes Received:
    24
    That is cool. I have my basic frame put together. I don't want to take it apart. I will get some more lock collars. I use the new collars to put some tension on like in the video. I will probably need to loosen the old collars then tighten them back up after the tension is set. Thanks.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice