Hello hive mind On my x32 all stepper voltage was different on each stepper and i think i was causse my y2 to code. The exclamation mark! to ajust them good. Where do i have to take the measurement ? Waiting your answer so i don’t fried my board. thanks
The voltage is constant on the stepper motors. The current is adjusted with the adjusters on the side of the X32. Read this docs:blackbox-x32:currentadjustment [OpenBuilds Documentation] There is no way to measure the setting, just look at where the screwdriver 'points' relative to minimum and maximum travel. The factory sets them all in the middle, that works for most motors on most machines.
VREF = a "reference" voltage.. Not THE voltage. Just follow the docs We reinvented how its done to make it easy