I am trying to get the 24 volt power supply and the Blackbox 32 setup. The problem is when I jog the x-axis and the Z axis they both move correct. However, the Y-axis, the gantry on one side goes forward and the other end goes backwards. According to the multi-meter the wires show I have all three axis in correctly in the Blackbox. When probed they all show continuity. One thing I noticed was the Documentation only shows the X 4 but not the X 32. Do not know if that might be the problem. Thanks in advance, Duane
Did you reverse one set of the Y-axis wires? docs:blackbox-x32:connect-nema23-reversed-y2 [OpenBuilds Documentation] With belt drive systems you reverse one set. With screw drives, you don't. Check the order of your Y-axis wires to make sure they all match the documentation.
You, Sir, are my best new friend!! That was it. And I thought I had gone through every page in the manual. Now I need to find the pages on calibrating the axis's. At the present I set a 1/2" jog distance but the router moved 3"!
CONTROL > Wizards and Tools > Calibration We have a video for that on our YouTube, see the Videos link on menu at top of this page
