I have not been able to get the x, y, and z Axis to move. checked all the wiring it is correct. I am using Openbuilds Nema 23 motors. Drivers all downloaded and installed. Connects to the program without a problem yet I get no movement from any of the axises. What am I doing wrong. Any help will be appreaciated. Thanks, Kevin
Peter this is a home built machine. What profile should I use? It is a lead screw machine with 2 motors on the y. Thank you so much for your help! Kevin
use the LEAD1010 and get it moving (turn homing off at first), then fine tune the speeds, lengths and homing , and importantly, calibration (use the wizard)
Grbl is mm internally. Thus its settings are all in metric. See Grbl v1.1 Configuration For daily use your can use Inch mode CAMs, and in CONTROL above the DROs click the Inch mode tab to set the UI up as Inch
Thanks for all the help. I have all 3 axis's working, limit switches, and all I have left is to get the vfd to start the router from the control software. Thanks again for the help, Kevin