Welcome to Our Community

Some features disabled for guests. Register Today.

Error #33 on G03 with Blackbox

Discussion in 'Control Software' started by Sylvain Michaud, Mar 5, 2022.

  1. Sylvain Michaud

    Builder

    Joined:
    Nov 3, 2020
    Messages:
    11
    Likes Received:
    0
    All firmware are up to date...

    Using Hypertherm plasma but for this test machine are off. All parts of cnc are grounded and I make special attention in wiring ( shielded...)

    Using Sheetcam ( up to date ) for cam software and GRBL post processor recommanded in other post...

    See this video :

    and files,

    Need help please

    Best regards
     

    Attached Files:

  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    13,753
    Likes Received:
    4,070
    Error 33 means the Gcode the post created is invalid and thus does not constitute a valid Arc
     
  3. Sylvain Michaud

    Builder

    Joined:
    Nov 3, 2020
    Messages:
    11
    Likes Received:
    0
    Blackbox can make arc with I and J gcodes right ?

    With cam.openbuilds.com... I make same parts with fusion -> export to DXF ->open in cam.openbuilds ->make gcodes and no arc are inside GCODES ?
     

    Attached Files:

    #3 Sylvain Michaud, Mar 5, 2022
    Last edited: Mar 5, 2022
  4. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    13,753
    Likes Received:
    4,070
    Grbl supports valid Arcs yes. OpenBuilds CAM doesn't generate Arcs no, uses interpolated line segments, not as optimised, being a free, basic, entry level CAM (;
     
  5. Sylvain Michaud

    Builder

    Joined:
    Nov 3, 2020
    Messages:
    11
    Likes Received:
    0
    Do you have idea to help me with this ? I can't see what is wrong with my G03 X15.202 Y30.798 I-2.956 J-1.225 ? Decimal ? I change from 0.0000 to 0.000 and no change...
    Do you have website or link for helping me ?

    I have contact Sheetcam admin and wait for return :)

    Thanks for your help and VERY fast reply :)
     
  6. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    13,753
    Likes Received:
    4,070
    Haven't used SheetCAM in years, so I don't have a better post around myself. See Grbl problems - sheetcam.com though, discussion mentions arc errors toward end of page 1 with another Post available on page 2. Getting into editing the post if needed may also be helpful
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice