Welcome to Our Community

Some features disabled for guests. Register Today.

Dixie C-Beam XL

Discussion in 'CNC Mills/Routers' started by WarEagle90, Jun 6, 2017.

  1. WarEagle90

    Builder

    Joined:
    Apr 20, 2017
    Messages:
    9
    Likes Received:
    8
  2. MaryD

    MaryD OpenBuilds Team

    Joined:
    Apr 13, 2016
    Messages:
    649
    Likes Received:
    639
    Looking good!
     
  3. WarEagle90

    Builder

    Joined:
    Apr 20, 2017
    Messages:
    9
    Likes Received:
    8
    First movement video .... I hope!!!

     
    Grantman likes this.
  4. MuchoBurrito

    Builder

    Joined:
    May 31, 2017
    Messages:
    4
    Likes Received:
    6
    Nice work so far. I look forward to your posts about using RPi3. I am interested in doing the same. Are there any sites you know of with good details on this?
     
  5. WarEagle90

    Builder

    Joined:
    Apr 20, 2017
    Messages:
    9
    Likes Received:
    8
    Thanks @MuchoBurrito . I poked around on the web to find out how to setup the RPi, but I didn't log any of the sites I used. I'll go back and see if I can find them again. It wasn't very hard though. I am a complete Linux noob and I got it running in a matter of a few minutes. There are a lot of good resources on YouTube also.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice