Separate names with a comma.
Some features disabled for guests. Register Today.
See my previous posts. Overall what you can try: Check eccentric spacers, check wiring, check pulley grub screws
Just for your information ;) It seems to be running again. Not really sure if it was the cables, the eccentric spacers or the pulley screws. But I...
Haha. Got to admit that I'm not a "mechanic" at all. Typical IT guy.... 1's and 0's. I chose the 1 (full power). I did an "air-run" and so far it...
Really appreciate your support! Second time to offer me to send over some parts :) I got the screws out and bought some m3 bolts and some loctite....
@Tobin seems like I got the same exact issue as you got. Mine was working fine all the way as well and suddenly starts to skip steps on the...
They were quiete loose before, so I tightened them and the problem was still there. Do you think at all that a double belt would/could help as...
Sorry for the late reply. I am using the exact settings Ryan has posted here once. I just did a complete resoldering of the cables. Hopefully this...
@Ryan Lock @Giarc Its been a while already. Unfortunately with the new drivers the problem seems to get worse and worse. So I got TB6600 drivers...
Thanks. But I just ordered the drivers that Giarc suggested. As I said, have never had any problems with the same settings. There must be...
Good to hear. But well, the DRVV8825s cost around 14 usd for 4 pieces, where the DQ5442MAs are 140 usd. At least I think there is quite a...
Nice. Can I use my 24V power unit with these? As far as I have seen, I can get 4 for around 140 usd. Would I need an additional fan? Thanks....
Ah. I attached a photo but seems like it didnt upload. I tried it again with a smaller part. Was the same problem pretty much at the same...
Hey guys! I'm having a little problem. I have always been cutting pine with a feed rate of 1700 mm/min (~67 ipm). Had no problems so far,...
That sounds like a great idea. Already thought about something similar. Was just wondering if it would loose too much rigidity. How large is your...
Got this machine for roughly a year now and I am so happy. I was just wondering if there is any way to upgrade the z-height. Are there plates...
So you tried to loosen all the eccentric spacers? By the way. I want to flatten my wasteboard. What is the maximum feedrate I should go for? If I...
Sweet. And its not a problem that this wire is copper and 2 meters long? What would be the longest length without any problems?
Hey there. After a long break I have some time to work on my CNC again. Unfortunately my wires to the motors are too short, because I want to lay...
Hey guys. I have been quite busy recently so unfortunately I only had a little bit to play around with my ooznest. Last week I did some test...
Ha, did my first two tests today. Maybe I will drill the holes tomorrow for the spoiler board. Still I am totally unsure which bits to buy. And...
