Separate names with a comma.
Some features disabled for guests. Register Today.
Really unluky.
@solarground. Took a picture of mine to compare. It is a jumper. Despite the picture quality due to low light, mine seems cleaner, clearly two...
It seems your electrical connection are wrong. From OB motor datasheet, I see RED/GREEN and BLU/YELLOW to be connected respectively to A1-A2 and...
@JustinTime : There is the command to enable the movement even without homing the machine. But that's a good point. @solarground: do you enable...
The other way round: you have to connect the NO pins, so they close the circuit when hit. for reference:...
I think the guilty is the G28 command. Try to cut it out and to me it will work ok. In addition, keep note that the last command in your file...
@Justin Dewoody, it sounds strange. Instead of Reset Zero, could you try the direct command "G92 x0 y0 z0" in the command section before sending...
It's really interesting. Curious to see how you'll accommodate the PSU and the electronic controls in the suitcase.
It must be 5V output, because if you connect the Pot, there is no one giving it the 5V. I exclude this can be the issue. To make the Pot working,...
Do not connect the 5V, it is needed only for the potentiometer to give it the max (5V) when you turn it all up. So, the issue is with the speed...
Justin, from what you say and what I can see in the xPro build, it seems you have it wired up correctly. Only suggestion I have at the moment is...
That's strange as well. When I was testing the modified driver for my RC motor used as spindle, using S command higher than the max, I couldn't...
Hi Justin, I'm using the xpro with variable speed controlling, but unfortunately I'm not using the spindle you have, so I cannot help you much on...
Easy is very easy. I had no experience at all and it worked out very easy. One board for everything, was really what I wanted to start with, and...
Enjoy your beer! I have the same type of issue up until 300 mm/min, both with UGCS and GRBL controller. Also, I use xPro V2 and steppers rated to...
I think @Akfreak refers to the AC INPUTS of the PSU, not the output that very likely is DC. So, yes, they can be in parallel to the AC wall plug...
You can have homing on only specific axes. It is not by configuring the $ variables, but it can be made through a "compile time" variable on one...
Very happy you solved it! It should work with GRBL controller too. Because sometime GRBL controller got errors/difficulties in interpreting some...
As suggested by Tweakie, here the files and some explanation on how to use this great project with GRBL 0.9g. I'll probably publish a build to go...
The $110-111 values are used by G0 commands, for fast movement and positioning. So, your error message is referring to the Fxxx command. My...