Welcome to Our Community

Some features disabled for guests. Register Today.

atflake
Last Activity:
Jan 11, 2021 at 12:11 PM
Joined:
Mar 2, 2016
Messages:
1
Likes Received:
0
Trophy Points:
1
Gender:
Male
Location:
Virginia

Share This Page

atflake

New, Male, from Virginia

Builder
atflake was last seen:
Jan 11, 2021
    1. daisosasen01
      daisosasen01
      Hi atflake, can you share your setting for your c-beam? I have the exact same setup as you including xPRO V3 stepper driver board. What software are you using? I'm currently trying to set all that up.
      If possible can you add me in facebook for faster response? [email protected]
    2. crnrstndes
      crnrstndes
      Hi, I just read your review on the C=Beam and I was wondering what electronics did you go with?? I used the Arduino Uno with GRBL Shield and it doesn't work properly.

      Thanks for your time!
      Steve B.
      1. atflake
        atflake
        I used the same board that was used in the original build by Mark. They sell it in the parts store,CNC xpro v2, just bought. Xpro v3 for a plasma table project. Card is pretty straight forward and have not had any problems with it.
        Nov 29, 2016
      2. atflake
        atflake
        I used the same board that was used in the original build by Mark. They sell it in the parts store,CNC xpro v2, just bought. Xpro v3 for a plasma table project. Card is pretty straight forward and have not had any problems with it.
        Nov 29, 2016
  • Loading...
  • Loading...
  • About

    Gender:
    Male
    Location:
    Virginia
  • loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice