Welcome to Our Community

Some features disabled for guests. Register Today.

Ramps 1.4 + 4x MK2

Discussion in 'Controller Boards' started by elib, Feb 9, 2017.

  1. elib

    elib New
    Builder

    Joined:
    Nov 28, 2016
    Messages:
    6
    Likes Received:
    0
    Hello,

    I'm currently building a 3D printer which is already working and have a build size of about 40x40x40cm
    To do it I have used 4x MK2 hot beds that are not working yet.

    I need your help to power and wire it. I'm not sur about what to use? Do I need another power supply? (I'm currently using a 10amp 12v power supply for the Ramps 1.4, Arduino mega and drivers).

    - How to power it?
    - How to mesure the T° as there will be 4 different board?

    The printer:
    upload_2017-2-9_12-0-25.png

    Thanks in advance.
    Edouard
     
  2. elib

    elib New
    Builder

    Joined:
    Nov 28, 2016
    Messages:
    6
    Likes Received:
    0

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice