Separate names with a comma.
Some features disabled for guests. Register Today.
Success! The grid is now 1cm junctions all around when I made a test while having the spindle move into dots from all directions to check both...
I cannot see/feel the pulley slipping on the X, but I'll be replacing the grub screws on all of them with cap screws just so that I can make...
While testing out the grid I plan to route into my spoil board, I have run into a problem that I hope someone is able to say, "Ah ha! I ran into...
Followup after replacing my 14awg non-shielded spindle cable with an 18awg shielded cable. SUCCESS! I have full control over my spindle location...
The customer service that I saw from Ooznest before I purchased mine was the main reason that, even though I live in the USA, I ordered from the UK.
Hi Ryan, yeah my order would have been before shipping those. I also had to do the fast decay on my controller which I think is standard now. I...
The VFD is mounted to the wall about 3 feet above the table, 2 feet back from the far end of the Y-axis. The line from the VFD to the spindle is...
Table Up - Back
Table Up
Table Lowered
After many life delays, I've finally got the Ooznest 1500x1500 machine fully built, mounted to wall and trying to surface my spoil board. I am now...
If you are trying to cut at 2000mm/min, make sure that the controller is set to allow it to actually get there (values 110-112 control x-z max...
My new build sounded like that when I first ran some jogging commands. I found a couple of things that was causing it in my case. First being the...
"It's ALIVE!" I was finally able to carve time out this weekend for assembly with my step-father. Amazing job on the instructions and labeling of...
The last package arrived this evening (apparently it was separated when the shipment was held for agency clearing in UPS's Louisville, Kentucky...