Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks man firing up the printer now! Will also see what aluminum i have laying around i think all i have is 1/8"
so i built the ob13 and the ox cnc off this site. I just started printing parts for this today cant wait to get started on it. just using the...
OK so i found the data sheet for my stepper does this look right to you guys a coil on left b coils on right. Again any help would be greatly...
Thanks man i have found this before to but still very confused as to tell what wire is which i know what wites are b coil and a coil but not sure...
Well i got my new Gecko G540 controller intoday and very excited to get it set up. Im having a bit of trouble finding out how to hook the motors...
This is true man it was a fun kit to put together and helped teach me how to test a board and check for breaks. Well i just placed an order for...
Great thanks for the input thats the one i have been looking into. I think that is the route i will go. The last controller i had to solder all...
I have a 24v power supply
So i wanted to get some input from you guys. My hobbycnc board has to go so im in the market for a new controller. My steppers are 8 wire and need...
Man you are totally right my prints look great with cura. i now have none of the problems i did before. Only one i still have is lets say i do the...
im using matter control awesome program. They have 3 slicer programs built in im using matter slicer
Any advice to help getting this to print better. This was at .1 layer height with 30% infill also spped around 30mm/s
[MEDIA]
Good news finally got the printer working great. The problem was def the stepper motor i replaced it with one i had laying around now all is good....
So after thinking about what could be not allowing the filament to flow freely i raised my z axis up and extruded some. It curls up right away and...
