Separate names with a comma.
Some features disabled for guests. Register Today.
Its a shame you didn't try DRV8825 drivers before buying new steppers, I couldn't run my NEMA 23's from the A4988's either.
So as I'm still waiting for parts after it horrific crash I began working on the wood cabinet, not being my favorite material to work on I think...
Thanks for the info Justin, wont make that mistake again.
So just figuring out where I went wrong, if I press the button to move the z axis 10mm in Octoprint the terminal cammand created is G1 Z10.0000...
Gutted
Messed up my printer pretty bad last-night. Stuffed up the end G-code script, I wanted the bed to move down from the nozzle by 100mm after a...
Yes it was.
Thanks for the tip Tim, I've wound everything back quite a bit if config.h which seems to have fix the problem for now, until I start winding it...
thanks Larry
So I bought Simplify3D and its AWESOME! here are some prints I've done, one is at .45 layer height and the small one at .2, both with a 0.6mm...
So after checking out this guys experiences, I'm pretty sure I'll end up getting rid of the bowden. I'll spend another day or 2 playing with...
I'm guessing your running DRV8825 Drivers as the A4988 cannot step at 1/32. As for the 495 @ 1/16 I'm pretty sure this is correct but I'll...
I'm using the A4988 at the moment set to 1/16. I got the figure from here https://www.indiegogo.com/projects/bulldog-extruder-project#/ however I...
Its a Bulldog XL Bulldog Extruder XL | Robotronics. Clint
Hi Steven, I'm not entirely sure what you mean, I have #define EXTRUDERS 1. The driver is a Bulldog XL, steps per mm set to 495. Any advice would...