Separate names with a comma.
Some features disabled for guests. Register Today.
Why not wall mount it on a hinged board and swing it down to use? I have seen other CNC’s mounted vertical ((New Vertical Oriented CNC Machine)...
I drilled thru one rail and tapped the other and screwed them together at 2 points about 1/3 in. Very sturdy.
andrew Adsit published a new build: Expands y-axis to 1000mm. 1/2 day build. Read more about this build...
[ATTACH] [ATTACH] [ATTACH] My OX is almost a year old, and there have been a few times that I needed a few more mms in the Y Axis (not a fan of X...
With a 1" bit, almost 50mm with my standard waste board. If I remove it and use the board below it, I get another 60mm. So far, it has been...
SOLVED: X Gantry not square to Y... First time, I cut the rails with a hack saw. Not even close. Tried to use a file to square up. Square off by...
I added a 4th wheel on each side. Prototype here: http://www.thingiverse.com/thing:1015574 Helped a bit, but thinking the different axis wheel is...
[ATTACH] [ATTACH]
Another update. After several awesome cuts using the $54 Chinese TB6600 4 axis controller board, I started to get interminent failure on one of...
Absolutely. Was careful to raise z to safe height or I think that would have happened. I am amazed that "go to zero" doesn't raise the z first,...
I am gaining respect for Mach3 as well. I struggled with the controller software (freeware) and it is so much better when you have supported s/w....
OK, an update. My OX with the TB6600 control board and Mach3 is running awesome. I have added an old XBOX 360 wired USB game control and...
http://www.aliexpress.com/item/5A-24V-40V-TB6600-4-Axis-Stepper-Motor-Driver-Board-for-CNC-Route-kit/32226142742.html?tracelog=ae-app-ios-sharefor-...
My initial build used the xPro V2 and I love the form factor and virtually everything about the all in one driver. But I did experience many of...
