Separate names with a comma.
Some features disabled for guests. Register Today.
This is how my bot is set up, you can see in the photos. My single screw is in the rear along with the two xy steppers. I never did a fully...
the calculator is on the second page of the BOM. I don't remember if mine has the formulas or not. The original c-bot BOM spreadsheet has a...
I need to remove that link for the tempered glass. DO NOT USE TEMPERED GLASS. That piece of glass worked out really well, until it actually...
Should be fairly easy to adjust the hole for a different bearing. F360 is parametric, just select the hole and adjust the size.
The "bench lathe" was kind of impressive Here are the leadscrew bases and the corresponding nut catch.
I modeled all these in fusion360, let me figure out how to export them.
The clamps for the belt are the same from the C-bot. This printer pretty much follows Carl's bot as far as assembly as well. You could use his...
They have always had a 30 day money back policy, nobody ever goes back
You can edit your post in my google group. I am the manager of the CTC 3D Printers group. I think that github and google groups are both good...
Electronics | Filastruder in the U.S. Kind of pricey once you add the LCD. Clone board mini with screen is only 140.
I dont think that it really matters with a triple leadscrew setup. The keep the x short is a mantra of the cantilevered bed folks. Again, I'm a...
There are sailfish coreXY builds for both 1280 and 2560 mega boards and the x3, hosted on the normal update site.
I know Ryan is using them now on his replicator and Dan just ordered a bunch of those adapters. I need to wrap up a few projects before I can...
@Carl Feniak Did you adjust the extrusion calculator to allow a bit more depth? I know there was some talk about it a while back, and I know that...
I have been reading this on my mobile for a couple of days now and I am glad I finally have the time to sit down at the laptop and pen a proper...
