Build List
-
Active Filters:
blue
![Embroidery machine with XY belt and pinion drive.](https://openbuilds.com/data/article_images/l/0/691.jpg?t=1398202839)
Build Author
sausagePaws
Views
73151
Embroidery machine with XY belt and pinion drive.
![](https://openbuilds.com/data/article_cat_images/s/0/295.jpg?t=0)
A simple Embroidery machine using an XY belt and pinion drive to drive a hoop under a standard sewing machine. Needle timing, machine power and stepper control are all provided by a PIC processor. A tablet provides the higher level formatting required for communicating with the PIC chip.
![DIY Embroidery Machine V2](https://openbuilds.com/data/article_images/l/8/8630.jpg?t=1560204694)
Build Author
sausagePaws
Views
1742750
DIY Embroidery Machine V2
![](https://openbuilds.com/data/article_cat_images/s/0/295.jpg?t=0)
My second attempt at an affordable sewing machine embroidery add on. This one uses readily available electronics modules and 3D printable parts where possible.
![Project Death Star - DistortedDesigns Laser Engraver](https://openbuilds.com/data/article_images/l/1/1728.jpg?t=1438013480)
Build Author
DistortedDesigns
Views
32563
Project Death Star - DistortedDesigns Laser Engraver
![](https://openbuilds.com/data/article_cat_images/s/0/303.jpg?t=0)
2 watt Laser Engraver, Simple, Fairly Low Cost, and Portable
![M Cubed 3 Axis Bluetooth CNC Controller](https://openbuilds.com/data/article_images/l/1/1648.jpg?t=1423954156)
Build Author
M^3
Views
16487
M Cubed 3 Axis Bluetooth CNC Controller
![](https://openbuilds.com/data/article_cat_images/s/0/295.jpg?t=0)
Low cost, Bluetooth enabled, 3 axis CNC controller. GRBL 0.9 compatible.
Another OX CNC Router
![](https://openbuilds.com/data/article_cat_images/s/0/286.jpg?t=0)
An OX CNC router using Blue OX Solutions gantry plates, a Bosch Colt router, and most of the remaining parts coming from Openbuilds parts store. Table has about 22"x55" cutting capacity and I am planning on a combination T-Slot and vacuum hold down system.
Sphinx 1000 x 500
![](https://openbuilds.com/data/article_cat_images/s/0/286.jpg?t=0)
Building a Sphinx based CNC based on Kyo's plans. Going with a 1000 x 500 table size.
![Loading...](styles/uix/xenforo/widgets/ajaxload.info_B4B4DC_facebook.gif)